![]() ![]() Rotate the gutter upward until its back edge slips into the hooks at the top of the back of the brackets (as shown).Lay the gutter into the brackets that you’ve lag-screwed to the fascia.To ensure a watertight joint, seal the rivets and the end-cap seam on the inside of the gutter with a high-quality siliconized caulk.Remove the temporary screw and replace it with a rivet.To do this, hold the end cap in place temporarily with a single sheet-metal screw, then drill a 1/8-inch-diameter hole and install one pop rivet (above). ![]() (If the gutter doesn’t turn a corner, fasten an end cap to each end.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |